How to eliminate: "Automatic arrangement of pipe feeds not possible - change pipe feeds route or H/C Zone parameters or arrange pipe feeds manually"

Produkt	InstalSystem 5
Art des Artikels	TYPICAL PROBLEM
Aktuell für Version	IS 5.0 Beta 28

Problem description

Problems associated with automatic generation of pipe feeds using the Die Route der Anbindeleitungen tool are diagnosed by means of the following message:

• Automatische Anordung der Anbindeleitungen nicht möglich. Ändern Sie bitte die Route oder deren Einstellungen oder zeichnen Sie die Anbindeleitungen manuell..

The message informs that pipe feeds could not be generated automatically by means of the Die Route der Anbindeleitungen tool, due to the following reasons:

• specified or automatically sized arrangement spacings are too large,
• manner of component crossing Die Route der Anbindeleitungen is inappropriate (for the algorithm of automatic pipe feed arrangement),
• number of component crossings Die Route der Anbindeleitungen is too large,
• Die Route der Anbindeleitungen components are located too close to each other,
• width of the strip within which Die Route der Anbindeleitungen generates pipe feeds is too small or too large (reaches beyond the borders of the heating zone).

Solution

• Specify smaller pipe feed arrangement spacing.

• Change manner of Die Route der Anbindeleitungen component arrangement.

• Increase width of Die Route der Anbindeleitungen component arrangement area.

• Draw pipe feeds manually.

Depending on design circumstances, or when pipe feeds cannot be generated automatically, the tool for manual arrangement of pipe feeds can be used.
For more information, see: Manual pipe feeds editing.